All the following were, at some time, sold under the Gemini name. Many of them were not actually manufactured by Gemini though. The expansion boards were all Nas-bus compatible, although the bus had now been renamed as the 80-BUS. The frames offered would only really accept the Gemini cards, as they were intended for the 8in x 8in format only rather than the 8in x 11in NASCOM computers. However, a NASCOM-2 would work as the CPU card even though it stuck out of the frame by 3in! The NASCOM-1 was of no use really as it needed special arrangements to fit it to the frame (but see the pictures of my machine to see how it was done!). The frames and motherboards were sold separately, so the motherboards were suitable for NASCOM systems if used without the frames. (Of course, many NASCOM systems DID fit into Gemini frames - the frame was never the same again though. You can work wonders with a bit of aluminium and a hacksaw!)
Many of the Gemini expansion boards were unsuitable to the NASCOM-1 due to insufficient I/O decoding on the main board. Also the lower clock speed of this machine meant that it couldn't really be used with disk systems. However, with a bit of hardware modification and a little luck in running the NASCOM-1 at 4MHz, both these problems were solvable.
Several of the cards are coded Gnnn on the actual card, whereas they are advertised as GMnnn. This may be irrelevent, but I thought I'd better mention it.
Note that the Gemini Galaxy 2 and Quantum 2000 computers were advertised as using two Z80 processors. They didn't happen to mention that only one was used as the system processor and the second as the graphics processor. Was this the beginning of "imaginative advertising" in computers?
- Gemini Galaxy 2
- GM903
- Complete system with 2 floppy drives
-
- Gemini Quantum 2000
- Complete system
-
- 19in Frame
- GM610
- Not intended for use with the NASCOM system as it only accepted 8 inch deep cards.
-
- GM656
- Suitable for use with all systems.
-
- 5 Slot Motherboard
- GM654
- Suitable for use with all systems.
-
- 8 Slot Motherboard
- GM655
- Suitable for use with all systems.
-
- 5 board frame
- GM662
- Not intended for use with the NASCOM system as it only accepted 8 inch deep cards.
-
- 6 Slot Motherboard
- GM682
- Suitable for use with all systems.
-
- 64k RAM board
- G802
- 64k dynamic RAM card
-
- ROM board (90k)
- G803
- sold without EPROMs!
-
- Disk controller
- G805
- 48TPI cased system connected via the PIO
-
- 3A Power Supply
- G807
-
- EPROM programmer
- G808
- Re-badged version of the Bits " PCs unit. For 2708 " 2716 EPROMs
-
- Floppy Disk board (92k)
- G809 (dated May 1982)
- 48/96TPI - replaced later by GM829. This was not suitable for use with the NASCOM-1 due to the slow processor.
-
- CPU board
- G811
- with 4 RAM/EPROM sockets (no RAM fitted)
-
- IVC card
- G812
- Intelligent Video Controller - 80 char/25 lines
-
- CPU/64k RAM board (192k)
- G813
- with RAM and CP/M compatible
-
- IEEE488 board
- EV814
-
- Multi I/O board
- G816
- with 6 I/O ports, 4 CTC, RTC
-
- 6A Power Supply
- G817
- switch mode type
-
- Twin Serial Port
- G818
- daughter board to fit G816 I/O board
-
- Keyboard
- GM821
- 59-key ASCII parallel interface keyboard with cursor keys
-
- RTC board
- G822
- Real-time clock kit - plugs into PIO
-
- A-D board
- GM824
- Re-badged version of an IO Research unit.
-
- Floppy drive unit
- GM825-1S or GM825-2S
- 1 or 2 5.25in floppy drive unit
-
- Keyboard
- GM827
- Parallel interface keyboard with cursor and function keys
-
- Static RAM board
- MP826
- 32k static RAM with battery backup
-
- 87 key keyboard
- GM827
- with user-definable function keys + numeric pad
-
- Disk Controller board
- G829
- Gemini - for 4 mixed 5.25in and 8in + SCSI HDD (Someone said that this was also used in the Lucas Logic "Winchester" hard disk drive!)
-
- SVC Video Card
- G832
- Super Video Controller (enhanced IVC)- 80 char/25 lines
-
- RAM-disk board
- GM833
- 512k dynamic RAM. Virtual disk operation.
-
- "Winchester" drive
- GM835
- 5.4Mb (!) hard disk drive subsystem (1450 UK Pounds in 1983!)
-
- Network adaptor
- G836
- Adaptor for their proprietory networking system.
-
- Colour vector graphics
- GM837
- Re-badged version of a Climax board. 256x256 display. 16 colours. Much cheaper than the PLUTO system!
-
- Prototyping card (58k)
- GM839
-
- 14 Slot Motherboard
- MP840
-
- 80-BUS card extender (164k)
- GM841
-
- 10A Power Supply
- G843
- switch mode type
-
- Serial I/O
- GM848
- 4 serial ports + PIO
-
- Floppy/SCSI
- G849
- also supports 1.2M drives - up to 8 devices
-
- Keyboard
- GM852S
- Serial interface keyboard with cursor and function keys
-
- EPROM programmer
- GM860
- "Bytewide" programmer with built-in mains supply.
- Monitor
- Badged Phoenix unit
- 12in green or amber phospher
-
- PLUTO Graphics
- IO828
- High power (for the time) graphics board. This was a basic version of the IO Research board.
-
nascom.info